All |
default password |
default password is: level2 |
|
All (unless DHCP enabled) |
error: cannot fully update system |
Make sure laptop IP address is set up on same subnet |
Gen 2: DHCP enabling will not cause this error message |
Gen 1 |
default IP address |
1.1.1.1 |
|
Gen 2 |
default IP address |
192.168.6.200 |
Not needed when using DHCP |
Gen 1 |
multicast UDP port # |
4096 |
Must have multicast enabled |
Gen 2 |
multicast UDP port # |
4096 |
Must have multicast enabled |
All |
Mac address programming |
All gateway Mac addresses must be programmed on near and also far sites |
|
Gen 2 |
cannot scan unit |
Make sure all signal connections are made before power is applied |
|
VIP-812 |
busy signal; devices are setup correctly and are on two different subnets |
Make sure multicast is enabled; if not then build static cache tables |
Newer tool is supposed to do this automatically |