Loading... Please wait...

Categories

our newsletter

Account Navigation

Call Helpline / Sales 01457 810 391

Email support@valcom.co.uk | sales@valcom.co.uk

Secured by SagePay PayPal GBP GBP USD
  • My Account
  • Order Status
  • Currency Converter

    Change

VOIP Troubleshooting

All default password default password is: level2  
All (unless DHCP enabled) error: cannot fully update system Make sure laptop IP address is set up on same subnet Gen 2: DHCP enabling will not cause this error message
Gen 1 default IP address 1.1.1.1  
Gen 2 default IP address 192.168.6.200 Not needed when using DHCP
Gen 1 multicast UDP port # 4096 Must have multicast enabled
Gen 2 multicast UDP port # 4096 Must have multicast enabled
All Mac address programming All gateway Mac addresses must be programmed on near and also far sites  
Gen 2 cannot scan unit Make sure all signal connections are made before power is applied  
VIP-812 busy signal; devices are setup correctly and are on two different subnets Make sure multicast is enabled; if not then build static cache tables Newer tool is supposed to do this automatically
Back to Top